You can change the elastic band/strap on the HAVS Protect sensor. You can buy your own elastic band that is 10 mm wide and 62 cm long, or buy through our shop.

<aside>

If you want to change the strap because it chafes between your fingers, we would first recommend having the strap a little looser. The sensor will stay on your hand even if the strap is a little loose. And if you wear gloves on top, they help keep the sensor in place too.

</aside>

We have both stiffer and softer straps, depending on what you want to use.

The strap goes in a single loop around your wrist, through the sensor, around your index finger, back into the sensor, around your little finger and then through the sensor again.

Do it like this:

1. Loosen the drawstring on the strap to be replaced. You may have to cut the ends of the strap to get the drawstring out.
2. Pull the belt out of the sensor.
3. Pull the new belt through the sensor. Start on a short side next to the charging connector. We use tweezers to help the strap through the tight holes.
   1. Make sure the strap is not twisted, it is more comfortable to have the strap flat against your skin.
4. Once you have pulled the strap through, thread both ends through the pull shoe.
5. Glue the ends after installation to make the strap last longer and reduce the risk of the drawbar slipping out.

<aside> ⚠️

NOTE! You should not unscrew the sensor!

</aside>

https://youtube.com/shorts/WaFN7U8205Y?feature=share